Audiovox PRO 9644aUGH Manual do Utilizador

1PRO PLM Installation InstructionsAvoid mounting components or routing wires nearhot surfacesAvoid mounting components or routing wires nearmoving par

101. 8 PIN MAIN HARNESSBLACK - Chassis Ground Source (-)Connect the BLACK wire to a solid chassis ground point using a ring terminal and self tapping

111. 8 PIN MAIN HARNESS, CONTINUEDBROWN - Negative Door Input (-)Locate the vehicle’s dome light or door pin switch wire.Verification: This wire will

122. 6 PIN HARNESS, CONTINUEDDK BLUE - Trunk Release Output (-) This wire provides a 500mA negative output capable of driving relays. For Contro

134. 3 PIN DOOR LOCK HARNESSRED - Lock Output (-)GREEN - Unlock Output (-)RED/BLACK - 2nd Door Unlock OutputNegative Switching and Negative Switching

14RED - Lock Output (-)GREEN - Unlock Output (-)RED/BLACK - 2nd Door Unlock OutputPositive Switching and Positive Switching with 2-step unlock feature

15RED - Lock Output (-)GREEN - Unlock Output (-)RED/BLACK - 2nd Door Unlock OutputOne Wire Negative Multiplexed and One Wire Negative Multiplexed with

16RED - Lock Output (-)GREEN - Unlock Output (-)RED/BLACK - 2nd Door Unlock OutputOne Wire Positive Multiplexed and One Wire Multiplexed With 2-step U

17RED - Lock Output (-)GREEN - Unlock Output (-)RED/BLACK - 2nd Door Unlock OutputReverse Polarity (5-Wire Door locks) and Reverse Polarity with 2-ste

18RED - Lock Output (-)GREEN - Unlock Output (-)RED/BLACK - 2nd Door Unlock OutputAdding Door ActuatorsAfter installing door actuators, (not supplied)

195. ACCESSORY CONNECTORS6 Pin Override Push-Button and LEDThe status LED / override button should be mounted in a visible and easily accessible loca

2PRO PLM SYSTEM LAYOUTBLACK GROUNDYELLOW IGNITIONPURPLE DOOR TRIGGER (+)RED PARKING LIGHT INPUTWHITE PARKING LIGHT OUTPUTBROWN DOOR TRIGGE

207. System Testing1. Follow each instruction below.2. Verify that the system operates as indicated under each instruction. Refer to the system owner

21Press DISARM:1. Doors unlock.2. Factory alarm (if equipped) is turned off.3. Siren/horn sounds once/ parking lights flash once.4. Courtesy lights tu

22 ITS IntroductionThe PRO PLM may be used as a ITS (Interior Theft Sensor) and when doing so it is designed to honk the horn if alight impact is de

23ITS LAYOUTBLACK GROUNDYELLOW IGNITIONPURPLE DOOR TRIGGER (+)RED N/AWHITE N/ABROWN DOOR TRIGGER (-)RED/WHITE +12 VOLT BATTERYORANGE N

24

3SETUP & PROGRAMMING - CONSUMER MODEConsumer Mode Transmitter Programming Bank1. Turn the ignition ON.2. Press and release the override button 3

4Transmitter Programming BankFeature Programming Bank 1 LED Flash 2 LED Flashes 3 LED Flashes1. Security Function ON OFF2. Passive Locks Passive Activ

5SETUP & PROGRAMMING - LOT MODELot Mode Transmitter Programming Bank - ACM Transmitter1. Turn the ignition ON.2. Press and release the override

6Transmitter Programming BankFeature Programming Bank 1 LED Flash 2 LED Flashes 3 LED Flashes1. Security Function ON OFF2. Passive Locks Passive Activ

7Transitioning into Lot Mode - ACM Transmitter1. Turn the ignition ON.2. Press and release the override button 3 times.3. The system will chirp 1 t

8Transitioning into Factory Keyless Upgrade Mode - BLUE1. Open a vehicle door.2. Enter the vehicle number into an ACM keypad.3. Press the UNLOCK bu

9Transitioning into Lot Mode1. Turn the ignition ON.2. Press and release the override button 3 times.3. The system will chirp 1 time.4. Press butt