Audiovox AS-9055T Manual do Utilizador Página 1

128-71841 of 16Kit Contents(1) - Control Module(2) - 1 Button High Frequency Transmitters(1) - 1 Channel Code Learning Receiver(1) - Multi Pin Input/O

128-718410 of 16103. Diagnostics:1. Be sure that programmable feature number #6 is set to the "Diagnostics On" mode.2. Press and hold the

128-718411 of 1611WARNING!!DO NOT RELEASE THIS VEHICLE TO THE CONSUMER UNTIL YOU CONFIRM THEOPERATION OF THE HOOD PIN SAFETY SHUT DOWN FEATURE.MANUAL

128-718412 of 16configuration prevents mechanical operation while the vehicle is in gear but offers no consideration for electrical operation.Because

128-718413 of 16METHOD 1To connect to the key in sensor as shown in method 1:A. Locate the control wire that connects the drivers door pin switch to t

128-718414 of 1614NOTE: A second 4002 series diode may be required to maintain the integrity of the hood open, shut down circuit. Ifthis is the case,

128-718415 of 1615

128-718416 of 16© 2004 Audiovox Electronics Corp., Hauppauge, NY 11788 128-7184

128-71842 of 16This Remote Start System is designed for use with Automatic Transmission Vehicles Only! The unit provides waitto start input for glow

128-71843 of 163THE RECEIVER/ANTENNA ASSEMBLY:The Superheterodyne Receiver Antenna Assembly provided with this unit allows routing from below the dash

128-71844 of 16NOTE: This wire must be connected to the vehicle side of the starter cut relay (when used). For the electrical neutralswitch configura

128-71845 of 16VIOLET WIRE: Accessory OutputConnect this wire to the Accessory wire from the ignition switch. This wire will show + 12 volts when the

128-71846 of 16BROWN w/ BLACK Tracer Wire: Positive Inhibit Input 2Any time + 12 Volts is applied to the Brown w/ Black tracer wire, the Remote Starte

128-71847 of 16LIGHT BLUE Wire: Ignition 3 / Shock Disable OutputThis wire provides a 300mA ground output that becomes active 3 seconds before the Rem

128-71848 of 16DARK GREEN Wire: Tach Sensor InputThis wire will continually monitor the engine tach rate while the unit is under power of the Remote

128-71849 of 16NOTE: The outputs above are low current outputs and must be used with a relay if the circuit's requirement ismore than 300 mA.2 P